The ribbon holders we sell (here) are easily threaded up to make your own collections and organise your ribbon supplies.  The holders have a euro slot at the top which means you can easily thread them onto book-rings or tension wires for pretty ribbon displays in your craft room. They can easily be transported to your crops or craft clubs.

We have taken a series of photos to show how easy it is to thread up the ribbon holders:

1 Cut a piece of card approximately 3cm x 10cm and fold it in half (this is your "needle")

2 Take your ribbons (if long fold them in half) and place onto the piece of card.

3 Fold the card over to sandwich the ribbons inbetween the card then thread the card through the bottom slot of the ribbon holder.

4 Pull the ribbon through at the top but don't remove the card.

5 Thread the card back through the first slit and pull to get your ribbons through and you have finished. The ribbons can be pulled through one at a time to cut to your desired length.

6 Pull the ribbon through